JP3 Motorsports FD RX7 Oil Catch Can Kits

We have assembled various iterations of oil catch can kits that use Radium Engineering's VTA (vent to atmosphere) Competition Catch Cans both large and XL.  We have developed a custom bracket that mounts the oil catch can on the front cross bar in the engine bay.  Our oil catch can kits are designed to route to an aftermarket oil filler neck that has provisions for an -8an connection and also integrate a second connection to the rear iron to provide optimum crankcase venting.  The first hose is from the oil fill neck to the catch can.  The second hose is from a hardline attached to the rear iron oil drain (used with the OEM twin turbos but blocked off when running single turbo).  Below you will find links to the various combinations we have assembled.  The video overview below goes into this setup in detail. Please allow 1-2 weeks after ordering for us to assemble kits.

UNASSEMBLED KITS:

For Turblown Oil Filler Necks:

Large Catch Can Kit

XL Catch Can Kit

For Non-Turblown Oil Filler Necks:

Large Catch Can Kit

XL Catch Can Kit

PRE-ASSEMBLED KITS:

For Turblown Oil Filler Necks:

Large Catch Can Kit with Push Lock Hose

XL Catch Can Kit with Push Lock Hose

Large Catch Can Kit with Race Rite Hose

XL Catch Can Kit with Race Rite Hose

For Non-Turblown Oil Filler Necks:

Large Catch Can Kit with Push Lock Hose

XL Catch Can Kit with Push Lock Hose

Large Catch Can Kit with Race Rite Hose

XL Catch Can Kit with Race Rite Hose

INDIVIDUAL COMPONENTS:

Catch Can Bracket ONLY

Large Catch Can with Bracket ONLY

XL Catch Can with Bracket ONLY